NSE7_SDW-6.4 Fortinet Exam Questions and Free Practice Test

Question 7

Refer to exhibits.
NSE7_SDW-6.4 dumps exhibit

Exhibit A shows the SD-WAN rules and exhibit B shows the traffic logs. The SD-WAN traffic logs reflect how FortiGate processed traffic.
Which two statements about how the configured SD-WAN rules are processing traffic are true? (Choose two.)

A. The implicit rule overrides all other rules because parameters widely cover sources and destinations.

B. SD-WAN rules are evaluated in the same way as firewall policies: from top to bottom.

C. The All_Access_Rules rule load balances Vimeo application traffic among SD-WAN member interfaces.

D. The initial session of an application goes through a learning phase in order to apply the correct rule.

Correct Answer:AB

Question 8

In the default SD-WAN minimum configuration, which two statements are correct when traffic matches the default implicit SD-WAN rule? (Choose two )

A. Traffic has matched none of the FortiGate policy routes.

B. Matched traffic failed RPF and was caught by the rule.

C. The FIB lookup resolved interface was the SD-WAN interface.

D. An absolute SD-WAN rule was defined and matched traffic.

Correct Answer:AC

Question 9

Refer to exhibits. Exhibit A.
NSE7_SDW-6.4 dumps exhibit
Exhibit B.

Exhibit A, which shows the SD-WAN performance SLA and exhibit B shows the health of the participating SD-WAN members.
Based on the exhibits, which statement is correct?

A. The dead member interface stays unavailable until an administrator manually brings the interface back.

B. The SLA state of port2 has exceeded three consecutive unanswered requests from the SLA server.

C. Port2 needs to wait 500 milliseconds to change the status from alive to dead.

D. Check interval is the time to wait before a packet sent by a member interface considered as lost.

Correct Answer:B

Question 10

Refer to the exhibit.
NSE7_SDW-6.4 dumps exhibit
Based on output shown in the exhibit, which two commands can be used by SD-WAN rules? (Choose two.)

A. set cost 15.

B. set source 100.64.1.1.

C. set priority 10.

D. set load-balance-mode source-ip-based.

Correct Answer:CD

Question 11

What are the two minimum configuration requirements for an outgoing interface to be selected once the SD-WAN logical interface is enabled? (Choose two )

A. Specify outgoing interface routing cost.

B. Configure SD-WAN rules interface preference.

C. Select SD-WAN balancing strategy.

D. Specify incoming interfaces in SD-WAN rules.

Correct Answer:AB

START NSE7_SDW-6.4 EXAM