Online JN0-682 Practice TestMore Juniper Products >

Free Juniper JN0-682 Exam Dumps Questions

Juniper JN0-682: Data Center Professional (JNCIP-DC)

- Get instant access to JN0-682 practice exam questions

- Get ready to pass the Data Center Professional (JNCIP-DC) exam right now using our Juniper JN0-682 exam package, which includes Juniper JN0-682 practice test plus an Juniper JN0-682 Exam Simulator.

- The best online JN0-682 exam study material and preparation tool is here.

4.5

(3045 ratings)

Question 1

You are configuring an MX Series router to act as a Layer 3 gateway to route traffic between VXLANs in different data centers across a WAN connection. In this scenario, what must you do to enable this communication?

A. Configure route reflectors.

B. Change the UDP port used by the VXLANs.

C. Configure the IRB interfaces to connect the VXLANs.

D. Enable PIM on all interfaces.

Correct Answer:C

Question 2

Exhibit.
JN0-682 dumps exhibit

You administer an EVPN-VXLAN fabric. You notice that there is no VXLAN traffic forwarding through the network.
Referring to the exhibit, which modification will solve the problem?

A. set firewall family inet filter allow-BGP term 1 from protocol udp set firewall family inet filter allow-BGP term 1 from destination-port 4789

B. set interfaces et-0/0/49 unit 0 family vxlan

C. set interfaces et-0/0/49 unit 0 family vpls

D. set firewall family inet filter allow-BGP term 1 from protocol tcp set firewall family inet filter allow-BGP term 1 from destination-port 4789

Correct Answer:A

Question 3

You are asked to deploy an Ethernet bridging design in a data center with the following criteria:
--routing must occur on the leaf devices.
--VTEPs must terminate on the leaf devices.
--facilitate inter-VLAN communication, -- lower latency with East-West traffic. Which architecture should you use in this scenario?

A. collapsed spine architecture

B. edge-routed bridging architecture

C. bridge overlay architecture

D. centrally-routed bridging architecture

Correct Answer:B

Question 4

Exhibit.
JN0-682 dumps exhibit
The two data centers shown in the exhibit need to be connected using EVPN. Which two statements are correct in this situation? (Choose two.)

A. Hosts in VLAN 10 can communicate with hosts in Data Center 2 using Layer 3.

B. Hosts in VLAN 10 can communicate with hosts in Data Center 2 using Layer 2.

C. Hosts in VLAN 202 can communicate using Layer 3 between data centers.

D. Hosts in VLAN 202 can communicate using Layer 2 between data centers.

Correct Answer:AD

Question 5

You are deploying a 3-stage Clos IP fabric in your data center. In this scenario, which statement is correct?

A. Each server-facing interface on a leaf node is always three hops away from other server-facing interfaces.

B. Each spine node must be physically connected to all other spine nodes.

C. There is an eight-spine node limitation.

D. No direct physical connections exist between leaf nodes.

Correct Answer:A

Question 6

Exhibit.
JN0-682 dumps exhibit
You are attempting to configure filter-based forwarding in your data center. All traffic from Host1 that is going to Host2 should be inspected by the data center firewall. You have verified that the traffic is being forwarded from router leaf L1's VRF-1 to its INSPECT-VRF. however, the traffic is not reaching service L2.
Referring to the exhibit, which two steps should you take to troubleshoot the problem? (choose two.)

A. Examine the INSPECT-VRF.evpn 0 route table on L1 for a default route that will direct the traffic to L2.

B. Examine the INSPECT-VRF.ine

C. 0 route table on L1 for a default route that will direct the traffic to L2.

D. Ensure that VRF-1 and INSPECT-VRF route targets on L1 and L2 match.

E. Ensure that the route target in the INSPECT-VRF of L1 matches the route target of the INSPECT-VRF of L2.

Correct Answer:BD

START JN0-682 EXAM