Online INSTC_V7 Practice TestMore BICSI Products >

Free BICSI INSTC_V7 Exam Dumps Questions

BICSI INSTC_V7: BICSI Installer 2 - Copper Exam

- Get instant access to INSTC_V7 practice exam questions

- Get ready to pass the BICSI Installer 2 - Copper Exam exam right now using our BICSI INSTC_V7 exam package, which includes BICSI INSTC_V7 practice test plus an BICSI INSTC_V7 Exam Simulator.

- The best online INSTC_V7 exam study material and preparation tool is here.

4.5

(5025 ratings)

Question 1

Which of the following terms describes the unwanted signal coupling from a disturbing pair of a 4-pair cable channel to a disturbed pair of another 4-pair channel?

A. NEXT - Near end crosstalk

B. ACRF - attenuation to crosstalk ratio far end

C. AXT - alien crosstalk

Correct Answer:C

Question 2

If you are working on a catwalk, you are required to wear ______ ?

A. Full body harness and two lanyards

B. Nothing, your fine on the catwalk

C. Safety belt

Correct Answer:A

Question 3

Which of the Two organizations jointly oversee the worldwide standardization of telecommunications cabling?

A. Alliance for Telecommunications Industry Solutions (ATIS) and Society for Cable Telecommunications Engineers (SCTE)

B. National Electrical Contractors Association (NECA) and National Fire Protection Association (NFPA)

C. Comite Europeen de Normalisation Electrotechnique (CENELEC) and Electronic Industries Association (EIA)

D. International Organization for Standardization (ISO) and International Electrotechnical Commission (IEC)

Correct Answer:D

Question 4

Which of the following is a building-serving space that houses large pieces of common active equipment?

A. TR

B. ER

C. TE

D. Mechanical Room

E. Battery room

Correct Answer:B

Question 5

Which of the following is used to measure the length of a 4-pair cable?

A. Time domain reflectometer (TDR)

B. Pair scanner

C. Cable-end locator kit

D. Tone generator

Correct Answer:A

Question 6

Which of the following should be used to install plywood in a telecommunications room if the edge of the board does NOT align with the wall studs?

A. Toggle bolts

B. Metal nails

C. Galvanized screws

Correct Answer:A

START INSTC_V7 EXAM