HPE6-A73 HP Exam Questions and Free Practice Test

Question 13

What is correct regarding policy-based routing?

A. Policies can only be applied to routed interfaces.

B. Policies can be applied inbound and outbound.

C. Monitoring of policy interfaces occurs every 60 seconds.

D. Policy actions include routing permitting or dropping traffic.

Correct Answer:A

Question 14

What is true regarding VSX and keepalives on AOS-CX switches?

A. A separate VLAN on the ISL link is used.

B. A VSX LAG for the keepalives is a best practice.

C. The OOBM port must be used.

D. A 1GbE or faster port is used.

Correct Answer:D

Question 15

Examine the VSX-related configuration of the core layer AOS-CX switch:
HPE6-A73 dumps exhibit
A network administrator is troubleshooting a connectivity issue involving the VSX LAG (link aggregation) between the core and access layer switch, during HW replacement of one of the core switches.
Which configuration should the administrator add to the core switch to fix this issue?

A. ICX-Tx-Core1(config)# vsxICX-Tx-Core1(config-vsx)# system-mac 02:01:00:00:01:00

B. ICX-Tx-Core1(config)# interface lag 1 multi-chassis ICX-Tx-Core1(config-if-lag-if)# mtu 9198

C. ICX-Tx-Core1(config)# interface 1/1/46-1/1/47ICX-Tx-Core1(config-if-vlan)# active-gateway ip 10.1.11.1 mac 02:02:00:00:01:00

D. ICX-Tx-Core1(config)# interface 1/1/45ICX-Tx-Core1(config-if-vlan)# active-gateway ip 192.168.0.0 mac 02:02:00:00:01:00

Correct Answer:D

Question 16

Examine the attached exhibit.
HPE6-A73 dumps exhibit
The network administrators is trying to add a remote location as area 3 to the network shown in the diagram. Based on current connection restrictions, the administrator cannot connect area 3 directly to area 0. The network is using AOS-CX switches.
Which feature should the administrator implement to provide connectivity to the remote location?

A. Not-so-stubby areas

B. Bidirectional forward detection (BFD)

C. OSPFv3

D. Virtual links

Correct Answer:D

Question 17

A network engineer is having a problem adding a custom-written script to an AOS-CX switch’s NAE GUI. The script was written in Python and was successfully added on other AOS-CX switches. The engineer examines the following items from the CLI of the switch:
HPE6-A73 dumps exhibit
What should the engineer perform to fix this issue?

A. Install the script’s signature before installing the newscript

B. Ensure the engineer’s desktop and the AOS-CX switch are synchronized to the same NTP server

C. Enable trust settings for the AOS-CX switch’s SSL certificate

D. Remove a script that is no longer used before installing the new script

Correct Answer:D

Question 18

An administrator is defining a VSX LAG on a pair of AOS-CX switches that are defined as primary and
secondary. The VSX LAG fails to establish successfully with a remote switch; however, after verification, the remote switch is configured correctly. The administrator narrows down the problem to the configuration on the AOS-CX switches.
What would cause this problem?

A. Local optimization was not enabled on the VSX LAG

B. The VSX LAG hash does not match the remote peer

C. The VSX LAG interfaces are in layer-3 mode

D. LACP was enabled in active mode on the VSX LAG

Correct Answer:B

START HPE6-A73 EXAM