H12-211 HUAWEI Exam Questions and Free Practice Test

Question 49

Which of the following commands can be used to view the current configurations on a Huawei router?

A. display current-configuration

B. display saved-configuration

C. view saved-configuration

D. show startup-configuration

Correct Answer:A

Question 50

Which of the following statements are correct?(Choose two)

A. A single collision domain exists between RTA and SWC.

B. A single broadcast domain exists between SWA and SWB.

C. A single collision domain exists between SWA and SWC.

D. A single broadcast domain exists between SWA and SWC.

Correct Answer:CD

Question 51

The administrator wishes to configure OSPF on a router in the network however the router has no loopbackinterface. Which value will be used as the router ID?

A. The lowest IP address of the router’s active interfaces.

B. The highest IP address of the router’s active interfaces.

C. The IP address of the management interface

D. The priority value of the router.

Correct Answer:B

Question 52

Destination/Mask protocol pre Cost Nexthop Interface
9.0.0.0/8 OSPF 10 50 1.1.1.1 Serial 1/0/0
9.1.0.0/16 RIP 100 5 2.2.2.2 Ethernet 0/0/1
Refer to the graphic. Which of the following statements is correct when this router forwards the packet to thedestination host 9.1.4.5?

A. The router selects the first entry to match the destination address of the packet because the preference ofOSPF is higher than the preference of RIP.

B. The router selects the second entry to match the destination address of the packet because the cost of RIPis lower than that of OSPF.

C. The router selects the second entry to match the destination address of the packetbecause the outgoinginterface is an Ethernet interfac

D. The forwarding speed of an Ethernet interface is faster than theforwarding speed of a serial interface

E. The router selects the second entry to match the destination address of the packet because the router willmatch the most specific address.

Correct Answer:D

Question 53

The network administrator wants to improve the performance of network transmission, what steps can theadministrator take?(Choose two)

A. Change the work mode to full duplex of each end station.

B. Link the end stations together using a switch.

C. Change the work mode to half duplex of each end station.

D. Link the end stations together using a hub.

Correct Answer:AB

Question 54

When using VRP, which of the following commands is used to configure the data link layer encapsulation typeof a serial interface as HDLC?

A. encapsulation hdlc

B. link-protocol hdlc

C. hdlc enable

D. link-protocol ppp

Correct Answer:B

START H12-211 EXAM