H12-211 HUAWEI Exam Questions and Free Practice Test

Question 43

In the case of Huawei router, what is the "-i" parameter in a Ping command issued on a VRP operating systemused to set?

A. Interface for sending an Echo Request packet

B. Source IP address for sending an Echo Request packet

C. Interface for receiving an Echo Reply packet

D. Destination IP address for receiving an Echo Reply packet

Correct Answer:A

Question 44

Which of the following VRP commands can be used to enter area 0 view?(Choose two)

A. [Huawei]ospf area 0

B. [Huawei-ospf-1]area 0

C. [Huawei-ospf-1]area 0.0.0.0

D. [Huawei-ospf-1]area 0 enable

Correct Answer:BC

Question 45

A user logged into a VRP supported device through telnet, but when attempting to
configure the device, foundthat he is unable to use the sytem-view command to enter the system-view. What are the possible reasons forthis?(Choose two)

A. The device’s VTY interface only provides permission for some telnet users to run the sytem-view command.

B. The user’s telnet software restricts use of this command.

C. The user’s privilege level is lower than the level associated with the system-view command.

D. The system-view command privilege level is lower than the level associated with the user.

Correct Answer:AC

Question 46

On the VRP platform, which of the following commands is used to configure the Router ID of a router as
1.1.1.1?

A. <Huawei>router id 1.1.1.1

B. [Huawei]router id 1.1.1.1

C. [Huawei]router-id 1.1.1.1

D. [Huawei]router id 1.1.1.1 255.255.255.255

Correct Answer:B

Question 47

When using VRP, which of the following commands is used to configure the PPP authentication method asPAP?

A. ppp pap

B. ppp authentication-pap

C. ppp authentication-mode pap

D. ppp pap-authentication

Correct Answer:C

Question 48

If AH and ESP are both required to protect data streams between IPsec peers, how many SecurityAssociations (SA) are required in total?

A. 1

B. 2

C. 3

D. 4

Correct Answer:D

START H12-211 EXAM