H12-211 HUAWEI Exam Questions and Free Practice Test

Question 37

After a command for displaying RIP route information is entered on a router, peer 192.168.1.2 on Serial1/0/0 isdisplayed in the returned result. What does 192.168.1.2 stand for?

A. Address of a RIP neighbor

B. Address of the port with the RIP protocol enabled

C. Next hop address of the RIP route

D. Transmission address of the RIP protocol

Correct Answer:A

Question 38

debugging rip 1
Sep 13 2013 11:07:20.974.1-05:13 R2 RIP/7/DBG: 6: 13414: RIP 1: Receiving v1 response
on
GigabitEthernet0/0/0 from 10.0.12.1 with 1 RTE
Sep 13 2013 11:07:20.974.2-05:13 R2 RIP/7/DBG: 6: 13465: RIP 1: Receive response
from 10.0.12.1 on GigabitEthernet0/0/0
Sep 13 2013 11:07:20.974.3-05:13 R2 RIP/7/DBG: 6: 13476: Packet: Version 1, Cmd
response, Length 24
Sep 13 2013 11:07:20.974.4-05:13 R2 RIP/7/DBG: 6: 13527: Dest 1.0.0.0, Cost 1
Sep 13 2013 11:07:20.974.5-05:13 R2 RIP/7/DBG: 6: 2688: RIP 1: Ignoring packet. This
version is notconfigured.
Refer to the debug output. Following configuration of R2, the administrator discovers that the behavior is not asexpected and performs debugging. Based on the output from the debug, what is the source of the problem?

A. R2 has configured an ACL to block the route to network 1.0.0.0

B. R2 has enabled split horizon.

C. R1 is using authentication, however R2 is not.

D. R2 is operating using RIPv2, while R1 is using RIPv1.

Correct Answer:D

Question 39

[RTA-GigabitEthernet0/0/0]nat outbound 2000 address-group 1
Refer to the configuration output. What does the value “2000” refer to?

A. It represents the ACL number.

B. It represents the NAT number.

C. It represents the translated port number.

D. It represents the number of bytes that can be translated before the address is returned to the public addresspool.

Correct Answer:A

Question 40

The network administrator wishes to forward data over an Eth-trunk, however associated member interfacesoperate at different rates. In terms of the resulting behavior, which of the following is true?

A. The two switches will not be able to communicate.

B. The higher rate member interfaces may incur packet loss.

C. The Eth-Trunk will work normally.

D. The lower rate member interfaces may incur packet loss.

Correct Answer:D

Question 41

What is the default authentication mode for the default_admin domain?

A. None

B. Local

C. Radius

D. 802.1X

Correct Answer:B

Question 42

Which of the following statements regarding the router ID in OSPF are incorrect?(Choose three)

A. The router IDs of OSPF routers in the same area must be the same, but can be different in different areas.

B. The router ID must be the IP address of an OSPF router interface.

C. The router ID must be configured manually.

D. A router running OSPF must have a router ID for it to operate properly.

Correct Answer:ABC

START H12-211 EXAM