DES-6322 EMC Exam Questions and Free Practice Test

Question 13

A systems engineer is tasked to configure a VxRail cluster and notices that the VxRail Deployment Wizard fails to launch. The engineer discovers that the software is corrupted.
What should the engineer do to address the issue?

A. Use the VMware Host Client and iDRAC to access the nodes for troubleshooting

B. Verify that the JSON file is not corrupted and has all the required values

C. Return the nodes to the original build state

D. Check vCenter and troubleshoot the build failure

Correct Answer:C

Question 14

A 2-node VxRail duster Is being deployed. Due to a preparation mistake, the host section fe missing. Use the VxRail simulator to fully deploy the cluster using the JSON file.
Node Names:
vcluster-esxO 15-vrack
vcluster-esxO 16-vrack
Starting IP
Address: 192.168.10.15
Rack Name: Virtual Rack
Rack Position: 15-16
Passwords: Passwordl23
!
ESXI Management
User: esxmgmt
When you have finished, continue to the next question.
DES-6322 dumps exhibit

Solution:
Pending
Send your suggestions for this question.

Does this meet the goal?

A. Yes

B. No

Correct Answer:A

Question 15

From what environment must a network administrator run VxRail network validation?

A. Windows PowerShell command prompt

B. Same subnet as VxRail Management Network

C. Top of Rack switches

D. VxRail Deployment Wizard

Correct Answer:C

Question 16

What is the correct sequence of steps to perform a RASR Factory Reset using an SD card?
DES-6322 dumps exhibit
Solution:

Does this meet the goal?

A. Yes

B. No

Correct Answer:A

Question 17

What is the maximum number of supported nodes in a VxRail Stretch Cluster?

A. 16

B. 30

C. 32

D. 64

Correct Answer:B

START DES-6322 EXAM