400-101 Cisco Exam Questions and Free Practice Test

Question 25

External EIGRP route exchange on routers R1 and R2 was failing because the routers had duplicate router IDs. You changed the eigrp router-id command on R1, but the problem persists. With additional action must you take to enable the routers to exchange routes?

A. Change the corresponding loopback address.

B. Change the router ID on R2.

C. Reset the EIGRP neighbor relationship.

D. Clear the EIGRP process.

Correct Answer:D

Question 26

What is the source MAC address of a BPDU frame that is sent out of a port?

A. the lowest MAC address on the switch

B. the highest MAC address on the switch

C. the MAC address of the individual port that is sending the BPDU

D. the same as the MAC address in the bridge ID

Correct Answer:C

Question 27

Which two statements about MLPPP are true? (Choose two)

A. It can bundle up to six T-1 interfaces

B. It supports fragmentation over multiple point-to-point links

C. It requires a group number to bundle the interfaces

D. The multilink interface number must match the group number

E. The MLPPP encapsulation process adds 8 extra bytes to each packet

Correct Answer:CD

Question 28

Refer to the exhibit.
400-101 dumps exhibit
Which two actions can you take to allow the network 172.29.224.0/24 to be reachable from peer 192.168.250.53? (Choose two)

A. Modify the community list to match community 64513:64090 attached to 172.29.224 .0/24.

B. Configure soft reconfiguration to peering 192.168.250.53.

C. Modify the outbound route map to permit all additional traffic.

D. Configure additional address families to peering 192.168.250.53.

E. Modify the inbound route map to permit all additional traffic

Correct Answer:AC

Question 29

Which two options are restrictions of BGP Outbound Route Filtering? (Choose two.)

A. It requires access lists to match routes.

B. It can be used only with eBGP.

C. It can be used only with iBGP.

D. It can be used only with IPv4 multicast.

E. Multicast is not supported.

Correct Answer:BE

Question 30

Refer to the exhibit.
400-101 dumps exhibit
While troubleshooting a connectivity issue between R1 and R2, you determine that R1's Loopback0 network is missing from R2's route table. What are two actions you could take to resolve the problem? (Choose two.)

A. Configure the same router ID under the EIGRP process of each router.

B. Configure a different router 10 under the EIGRP process of each router.

C. Increase the distance of internal EIGRP routes on R1.

D. Increase the distance of external EIGRP routes on R1.

E. Configure default metrics under the router eigrp process.

F. Add EIGRP metrics that the redistribute connected command or R1.

Correct Answer:EF

START 400-101 EXAM