400-101 Cisco Exam Questions and Free Practice Test

Question 19

Refer to the exhibit,
400-101 dumps exhibit
how can you configure R6 so that traffic returns to subnet 172.16.6.0/24 via R5?

A. Configure the neighbor 10.5.6.5 send-community standard command

B. Advertise prefix 172.16.6.0/24 to neighbor R5 with metric 80

C. Set the local preference for all prefixes received from neighbor R5 to 200

D. Advertise prefix 172.16.6.0/24 to neighbor R5 with AS 65006 prepended.

Correct Answer:A

Question 20

DRAG DROP
Drag and drop each IPv6 neighbor discovery message type on the left to the corresponding description on the right.
400-101 dumps exhibit
Solution:

Does this meet the goal?

A. Yes

B. No

Correct Answer:A

Question 21

Refer to the exhibit.
400-101 dumps exhibit
Router A is connected as BGP neighbor to routers B and C. Which path does router A use to get to AS 65010?

A. through router C because it has a higher local preference.

B. will load balance because both routes have the same Med value.

C. through router B because the default local preference is 500 and higher than router C.

D. through router B because ii has the shortest AS path.

Correct Answer:A

Question 22

Refer to the exhibit.
400-101 dumps exhibit
You are configuring Router 1 and Router 2 for L2TPv3 tunneling. Which two additional configurations
are required to enable Router1 and Router 2 to establish the tunnel? (Choose two)

A. Router1 must be configured to encapsulate traffic by using L2TPv3 under the pseudowire-class R1 to R2

B. Cisco Discovery Protocol must be configured on interface FastEthernet 1/0 on router1

C. An IP address must be configured on interface FastEthernet 1/0 on router1

D. Loopback 0 on Router1 must be advertised to Router2

E. Cisco Express Forwarding must be disabled on Router1

Correct Answer:AD

Question 23

DRAG DROP
Drag and drop each SNMP feature from the left onto the correct SNMP version on the right
400-101 dumps exhibit
Solution:

Does this meet the goal?

A. Yes

B. No

Correct Answer:A

Question 24

Which two statements about QoS marking are true? (Choose two)

A. The set-discard-class command can be configured for ATM and MPLS protocols

B. It can use a table map to mark traffic

C. It requires Cisco Express forwarding to be enabled on the sending interface and the receivinginterface

D. It is supported on tunnel interfaces

E. It is supported on Fast EthernetChannel and ATM SVC interfaces

Correct Answer:AD

START 400-101 EXAM