400-101 Cisco Exam Questions and Free Practice Test

Question 61

Which three actions are required when configuring NAT-PT? (Choose

A. Specify an IPv4-to-IPv6 translation

B. Specify an IPv6-to-IPv4 translation

C. Specify a ::/32 prefix that will map to an IPv6 address

D. Specify a ::/96 prefix that will map to an IPV4 address

E. Specify a ::/48 prefix that will map to a MAC address

F. Enable NAT-PT globally

Correct Answer:ABD

Question 62

DRAG DROP
Drag and drop each statement about routing protocols on the left to the matching routing protocol type on the right. Select and Place:
400-101 dumps exhibit
Solution:

Does this meet the goal?

A. Yes

B. No

Correct Answer:A

Question 63

Refer to the exhibit.
400-101 dumps exhibit
Which two conclusions can you draw from this output? (Choose two.)

A. The device that produced the output uses the same interface to send and receive traffic to and from the device at 10.9.132.254

B. The device at 192.168.5.119 is on the same subnet as the next hop for the device at 10.9.132.254

C. The device at the 192.168.5.119 routing table has an ARP entry for the device at 10.9.132.254

D. The device that produced the output uses different interfaces to send and receive traffic to and from the device at 10.9.132.254

E. The packet was source-routed

Correct Answer:AB

Question 64

Which two statements about CEF polarization are true? (Choose two)

A. The AND operation is performed on the higher- order bits of the source and destination IP address

B. A single link is chosen for all flows

C. The AND operation is performed on the lowe

D. order bits of the source and destination IP address

E. After the XOR process, the flow is processed in the distribution Layer with a different hashing algorithm

F. It can be prevented by alternating the hashing inputs

G. When enabled, it allows all links to be used efficiently for different traffic flows

Correct Answer:B.E

Question 65

When you deploy DMVPN, what is the purpose of the command crypto is a kmp key ciscotest address 0.0.0.0 0.0.0.0?

A. It is configured on hub and spoke router to establish peering

B. It is configured on hub to set the pre-shared key for the spoke routers

C. It is configured on the spokes to indicate the hub router

D. It is configured on the Internet PE routers to allow traffic to traverse the ISP core

Correct Answer:B

Question 66

What are three interfaces types or submodules on which PPPoE client can be started? (Choose three.)

A. Serial

B. Loopback

C. GRE tunnel

D. Ethernet

E. SVI

F. ATM PVC

Correct Answer:ADF

START 400-101 EXAM