Question 7
Refer to the exhibit.
An engineer is configuring an EtherChannel between Switch1 and Switch2 and notices the console message on switch2. Based on the output, which action resolves this issue?
Correct Answer:A
Question 8
Refer to the exhibit.
An engineer must create a configuration that executes the show run command and then terminates the session when user CCNP legs in. Which configuration change is required''
Correct Answer:C
The autocommand causes the specified command to be issued automatically after the user logs in. When the command is complete, the session is terminated. Because the command can be any length and can contain embedded spaces, commands using the autocommand keyword must be the last option on the line. In this specific question, we have to enter this line username CCNP autocommand show running-config.
Question 9
Which cisco DNA center application is responsible for group-based accesss control permissions?
Correct Answer:D
Question 10
Refer to the exhibit.
Which two commands are needed to allow for full reachability between AS 1000 and AS 2000? (Choose two)
Correct Answer:BC
Question 11
Refer to the exhibit.
An engineer configures monitoring on SW1 and enters the show command to verify operation. What does the output confirm?
Correct Answer:D
SW1 has been configured with the following commands:
SW1(config)#monitor session 1 source remote vlan 50 SW1(config)#monitor session 2 source interface fa0/14 SW1(config)#monitor session 2 destination interface fa0/15
The session 1 on SW1 was configured for Remote SPAN (RSPAN) while session 2 was configured for local SPAN. For RSPAN we need to configure the destination port to complete the configuration.
Note: In fact we cannot create such a session like session 1 because if we only configure Source RSPAN VLAN 50 (with the command monitor session 1 source remote vlan 50) then we will receive a Type: Remote Source Session (not Remote Destination Session).
Question 12
At which Layer does Cisco DNA Center support REST controls?
Correct Answer:D