Online 300-510 Practice TestMore Cisco Products >

Free Cisco 300-510 Exam Dumps Questions

Cisco 300-510: Implementing Cisco Service Provider Advanced Routing Solutions (SPRI)

- Get instant access to 300-510 practice exam questions

- Get ready to pass the Implementing Cisco Service Provider Advanced Routing Solutions (SPRI) exam right now using our Cisco 300-510 exam package, which includes Cisco 300-510 practice test plus an Cisco 300-510 Exam Simulator.

- The best online 300-510 exam study material and preparation tool is here.

4.5

(8235 ratings)

Question 1

300-510 dumps exhibit
Refer to the exhibit. Router 1 has established an SR-TE tunnel with router 2. Which statement describes this configuration?

A. Router 1 has a list of labels used to explicitly lay out a path to router 2.

B. Router 1 and router 2 have a bidirectional tunnel set up with dynamic path selection.

C. Router 1 is the head-end tunnel and has dynamically chosen a path to router 2.

D. Router 2 is the head-end tunnel and has explicitly set a path to router 1.

Correct Answer:C

Question 2

300-510 dumps exhibit
Refer to the exhibit. A network engineer implemented this segment routing configuration. Which statement about the output is true?

A. This range conflicts with the segment routing local block range.

B. The device must be reloaded for these ranges to be allocated and used.

C. The default segment routing global block range is being used on this device.

D. A nondefault segment routing global block range is being used on this device.

Correct Answer:D

Question 3

300-510 dumps exhibit
Refer to the exhibit. CE1 is the gateway router into the provider network via PE1. A network operator must inject a default route into OSPF area 0. All devices inside area 0 must be able to reach PE1. Which configuration achieves this goal?

A. 300-510 dumps exhibit B.

Correct Answer:B

Question 4

You have configured MSDP peering between two autonomous systems that pass traffic between two sites, but the peering has failed to come up. Which task do you perform to begin troubleshooting the problem?

A. Verify that multicast has been disabled globally

B. Verify that PIM-DM is configured on the source interface

C. Verify that both source interfaces are reachable from both peers

D. Verify that the two MSDP peers allow asymmetric routing

Correct Answer:C

Question 5

300-510 dumps exhibit
Refer to the exhibit. A network operator is getting the route for 10.11.11 0/24 from two upstream providers on #XR3. The network operator must configure #XR3 to force the 10.11.11.0/24 prefix to route via next hop of 10.0.0.9 as primary when available. Which of these can the operator use the routing policy language for, to enforce this traffic forwarding path?

A. weight of 0 on the prefix coming from 192.168.0.2

B. lower local preference on the prefix coming from 192.168.0.2

C. higher local preference on the prefix coming from 192.168.0.1

D. weight of 100 on the prefix coming from 192.168.0.1

Correct Answer:C

Question 6

300-510 dumps exhibit
Refer to the exhibit. A network operator is working to filter routes from being advertised that are covered under an aggregate announcement. The receiving router of the aggregate announcement block is still getting some of the more specific routes plus the aggregate. Which configuration change ensures that only the aggregate is announced now and in the future if other networks are to be added?

A. Configure the summary-only keyword on the aggregate command

B. Set each specific route in the AGGRO policy to drop instead of suppress-route

C. Filter the routes on the receiving router

D. Set each specific route in the AGGRO policy to remove instead of suppress-route

Correct Answer:A

START 300-510 EXAM